How to adjust the big throttle of the chainsaw?

1. Air leakage (crankshaft oil seal, cylinder gasket, throat, etc.).

2. If the carburetor is not adjusted properly, adjust the L needle and T needle again.

3. Pull the cylinder (can only be replaced).

When the chainsaw is sawing wood, the reason for the flameout when the accelerator is increased

1. Check whether the damper is open.

2. Check whether the air filter is clean.

3. After the flame is turned off, check if there is much oil on the spark plug. If the oil can be thrown off, it is the problem of the carburetor. Check the oil supply first, the oil circuit does not leak oil or air, turn the L needle of the carburetor to the right to the end, and then turn it to the left for one and a half times.

4. If it can be held at low speed, but the engine will turn off as soon as the accelerator is added, it is a compression problem. It is possible that there is a gap between the pistons of the cylinder block or the gasket on the cylinder block is leaking. In this case, you can only go to the maintenance station for maintenance. Crepu chain saws are of high quality, easy to use, durable, and provide a full range of integrated services. Welcome to buy.