Chain saws may have various problems during use, but how to solve these problems when they are encountered? When the chain saw cannot be oiled or the chain saw consumes a lot of oil, have you paid attention to how to adjust it? And how do you install the wooden teeth of the chain saw? Today I will mainly talk about these issues.







First. What should I do if the chain saw cannot be oiled?
1. First, check whether the carburetor is too thin;
2. Secondly, whether the chain saw is leaking;
The adjustment method of the chain saw not being able to add oil to the carburetor has a great influence. When it is too thin, the oil will be less and the gas will be too much, resulting in the burning of the mixture is too thin, so that the phenomenon of not being able to add oil during use; mechanical leakage; Gas can also cause the chain saw to not be oiled during use!

Second. What should I do if the chain saw consumes too much fuel?
First of all, we must determine a few conditions:
1. Is the chain saw a light chain saw (displacement less than 78) or a heavy chain saw (displacement greater than 78)? The working principle of the two chain saws is different, and the fuel consumption is also different. The light chain saw is more fuel-efficient than the heavy chain saw, but the power light chain saw is smaller and can only cut trees with a diameter of less than 50cm, and the tree quality cannot be particularly hard.
2. Does the oil consumption of a chain saw consume fuel when a new chain saw is used, or does it consume fuel after using an old one? If the oil consumption of a new chain saw is higher than that of a chain saw of the same condition, it is a problem with the carburetor. It is enough to adjust the carburetor or replace the carburetor. If the old machine consumes fuel, then check the cause. See if the gasoline filter and air filter are dirty, or the chain is not sharp enough, or the cylinder block is slightly worn. In short, the specific situation depends on the condition of the machine. If you can't operate it, you must send it to a professional for repair.

Third. How to install the wooden teeth of the chain saw?
When the chain saw inserting wood teeth are installed, the thorns are upward, and it is installed on the machine, and the wood can be stuck when sawing the wood. Chain saw is a kind of demolition equipment. According to the function and driving mode, it can be divided into motorized chain saw, non-motorized chain saw, concrete chain saw, etc. Also pay attention to checking the chain when installing the wooden teeth.
1. Check the tension of the saw chain frequently, turn off the engine and wear protective gloves when checking and adjusting. The proper tension is when the chain is hung on the lower part of the guide plate, the chain can be pulled by hand.
2. A little oil must always be spilled from the chain. The oil level of the saw chain lubrication and lubricating oil tank must be checked every time before work. The chain must not work without lubrication. If a dry chain is used, the cutting device will be damaged.
3. Never use old engine oil. Old engine oil cannot meet the lubrication requirements and is not suitable for chain lubrication.
4. If the oil level in the oil tank does not decrease, it may be that the lubrication delivery has failed. The chain lubrication should be checked, and the oil circuit should be checked. Passing through a contaminated filter can also lead to poor lubricating oil supply. Clean or replace the lubricating oil filter in the connecting pipe between the oil tank and the pump.